Earthworks

Garry Childs

All of my work is formed on the potters wheel from terra-cotta clay. I apply glazes and pigments to my pots when they have reached a state potters call “leather-hard” which is when the clay has stiffened up enough to handle but is not completely dry. I usually do this by spraying but sometimes also with a brush. I then carve through the glaze into the still damp clay to achieve the various patterns seen on my work.

Some of the pieces in the show utilize a combination of glazes and a metallic slip coating areas on the pot. I particularly like the way the slip gets a slightly bronze tone on some pieces.

I also have several pots that are a continuation of my “Red Clay” series that use local clays dug straight from the ground to develop texture. These pieces are much heavier textured than I have done in the past and incorporate some additional colors.

It is Springtime so naturally there will be planters included in the show. I make planters in three general sizes. The smallest are approximately twelve inches wide and tall measured on the outside, the medium 15″ x 15″ and the large are 18″ x 18″.  The 12″ size fit nicely on most steps and are the perfect size for growing herbs on your deck or patio. Larger sizes are available on a custom basis.  All have two drainage holes in the bottom of the pot and are suitable for use both indoors and outside in moderate climates.

Advertisements